Rogers Project Circuit Board

July 05, 2015

Well hope y'all had a good 4th!!

The Rogers Project continues…

Here we have the circuit card with eyelets installed. Each one is inserted by hand and set using a staking tool and hammer.. takes about 10 min…..

Next we have the near finished circuit board. Note the different caps and resistor types. I have a method to my madness, and yes it works. A combination of old and new precisely chosen for its specific application. There are many reasons to choose a part, I could write a book on this but I would rather build instead. -Ossie

Also in News

No longer producing Amps

May 19, 2019

As per the previous post, we have run out of our custom materials for building amplifiers. Leaving these pages up for reference only. Please visit us at our Solderless Cables site to see what we are currently up to.

View full article →

Limited Production Of All Current Models

October 14, 2016

You'll notice that all current models are now in limited production. That means when the chassis' and parts for these models are gone, we will cease production of these amps. We have parts for all models, so don't hesitate to contact us with an order.  Currently we are working on some new projects and a complete redesign of cabs and chassis' as well as a few surprises.

View full article →

Moving the Shop

September 01, 2015

Just wanted to inform everybody that we we are in the process of moving the shop to a new location. We are open and business is running as usual, we're still designing/building/shipping amps. If you need to contact us please email

View full article →